Polotentsesushiteli. «Foreign guests» — water polotentsesushitel of
Models of the imported production for this day are surpassed by Russian in design, but not on quality a little. At all this put even not so much in it, how many in basic distinctions aspect of operation of polotentsesushitel in our country and abroad. In the Russian Federation them connect to GVS system, where liquid is saturated oxygen (and in a combination to hot water it causes the strongest corrosion on internal surfaces of steel pipes) and different impurity. Not including that, «the national product» is ready to maintain jumps of working pressure, seasonal shutdowns and others «small troubles».
In Europe water units make of black steel in the width which is not surpassing 1–1,25 mm, and connect to heating systems from which air is removed. Pressure there low, and water passes special cleaning of impurity. And in our GVS system the devices delivered from another states hardly will sustain more than 2-3 months of operation because the material designated above with assistance with oxygen is exposed to corrosion. Well and at installation they demand more efforts, than Russian that is connected with discrepancy of diameters of a working part and connecting parts with pipes. Vobshchem, such disagreements will not cause in the good expert of special difficulties — the range of adapters, a fitting, shutoff valves and other adaptations rather wide.
And here if the imported design radiator is intended for the suburban house with a good complex of water purification, equal on beauty and quality it is simple to it not to find! The wide range production of the Italian companies IPSAP, BRANDONI, the Belgian JAGA, the German KERMI, the German-Swiss ZEHNDER, etc. However, forms cost of «foreign features» 10 times more Russian analogs — from 5 thousand roubles.
As the candidate the electric can serve water devices. As well as the above-stated brothers, it is simple to establish them, after all laying of additional pipes and intervention in GVS system here are not required. The unique difference — connection to a network in 220 V.Sposob of installation of an electric polotentsesushitel depends on model: usually it fix to one of walls by means of fastenings. Similar copies not only in a bathroom, well and in kitchen, in the nursery and other rooms have. If necessary the unit without effort disconnect, having simply pulled out a cord from the socket (in aspects of a room with the overestimated humidity the socket should be protected from this misfortune). Its power consumption does not surpass property of the standard filament lamp — 100 W. Moreover, the device does not depend on existence or lack of boiled water in your cranes. Perhaps, directly above-stated preconditions influence growing popularity of this type of polotentsesushitel.
On appearance it is same "snake" (or "short flight of stairs", or still something), only equipped with the heating electroboss — the built-in Tan. Such designs are made of steel and filled with mineral oil, mixes on its base or water. Oil models it is slightly better, as in case of critical blackout they for a long time keep (and respectively, and give) warmly. But do not forget: because Tan has a certain contact to the case, similar polotentsesushitel demand neotklonimy grounding. Cost of an electric oil model of production of Spain, Finland, Sweden, the Russian Federation fluctuates from 800 to 3 thousand roubles.